Interior Demolition in Colorado Springs
Interior demolition clears out what a remodel calls for (cabinets, flooring, dropped ceilings, non-load-bearing walls) and leaves the building's frame standing. Cyclone Kleen Up, based in Pueblo West, is a CDPHE-certified asbestos abatement contractor, so asbestos found before a Springs strip-out can be removed by the same company. Our own crews do the strip-out work.
If you're looking for a demolition contractor in Colorado Springs for a strip-out, start with the permit question. In Colorado Springs, a strip-out and a full teardown go through the same permit office on different paths. The Pikes Peak Regional Building Department (PPRBD) issues both kinds of permit, and which one applies depends on whether the whole structure is coming down.
The city's homes are younger than Pueblo's, but not new: about 39% were built before 1980 and 23% before 1970 (Census Bureau estimates for 2020 to 2024). Many predate the 1978 lead paint cutoff, and materials from those years may contain asbestos.
What we handle: demolition cleanup · site prep · asbestos abatement in Colorado Springs · selective demolition
Wrecking permit or interior permit? How PPRBD splits it
PPRBD's handout draws the line: a wrecking permit is "required when an entire structure is being removed," and "Interior demolition is different and may require an interior non load bearing demolition permit." A wrecking permit asks for more, including:
- a licensed wrecking contractor's ID number;
- proof of insurance;
- proof that gas and electric service are cut off;
- a "Permit from the Colorado Department of Public Health and Environment for asbestos and debris removal."
For a kitchen or office strip-out, check with PPRBD (719-327-2880) which permit your scope needs. Its office is at 2880 International Circle and serves Colorado Springs and the rest of El Paso County. Plan the permit before you book the crew, since the wrong permit can stall a job.
Asbestos first, on either path
Under Colorado's asbestos rule, interior demolition in Colorado Springs is usually a "renovation": that's any change to a building that leaves its load-bearing parts alone. Taking out a beam or bearing wall makes it "demolition" (Reg. 8, Part B, definitions I.B.40 and I.B.94). Demolition always needs 10 working days' notice to CDPHE. For a renovation, the asbestos steps start once the work passes the state's set amounts, which are smaller for a house than for an office or store (I.B.119; numbers on our asbestos abatement page). Past them, a certified inspector samples first, or the owner treats the material as asbestos (III.A.1).
Lead paint in older Springs homes
EPA runs the lead renovation rule in Colorado. For paid work in homes built before 1978, its definition of renovation "includes... the removal of building components (e.g., walls, ceilings, plumbing, windows)" (40 CFR 745.83). A strip-out in an older Springs house is covered. Ask any contractor about EPA lead-safe certification before the walls come down. Cyclone is EPA Lead-Safe (RRP) certified.
Asbestos removal before Springs teardowns
Our Colorado Springs record is abatement ahead of demolition. For IBEW in April 2022, we abated more than 10,000 square feet of CMU block filler, plus drywall, so the building could be torn down. For Equity Group in August 2019, we removed more than 15,000 square feet of asbestos before the old building came down. Both were cleared for demolition on time. Our work on both was abatement only. Equity Group is a repeat customer: we've abated more than 30 buildings for them in the past ten years.
Utilities: allow 5 to 10 business days
When service has to come off a building, Colorado Springs Utilities says removals are "typically completed in 5-10 business days." Build that into the schedule before the crew date is set. When a job needs gas or electric service disconnected, Cyclone arranges it.
Debris and recycling
Asbestos waste goes only to a landfill approved for it; on CDPHE's 2019 list, the Colorado Springs Landfill on Blaney Road takes it (confirm with the facility). Clean concrete, scrap metal and reusable fixtures can go to local recyclers and reuse stores instead of the landfill. Cyclone recycles concrete and metal when it can. It uses its own roll-offs on its jobs, which keeps waste loads under control.
A Springs interior demolition job, step by step
- 1Call for an estimate
We settle the scope, including whether anything load-bearing is involved. That answer picks the PPRBD permit.
- 2Asbestos and lead check
Before anything is pulled, a certified inspector with no tie to the contractor samples the materials in the way. If the lab finds asbestos above the state's amounts, a certified crew removes it before the strip-out.
- 3Permit
The PPRBD permit that fits the scope is issued before work starts: an interior non-load-bearing demolition permit for a strip-out, or a wrecking permit for a whole structure.
- 4Utilities
If service comes off the building, allow Colorado Springs Utilities 5 to 10 business days.
- 5Strip-out and haul-off
The planned materials come out; debris goes to an approved landfill or a recycler. We finish with a HEPA vacuum of the work area.
What interior demolition costs in Colorado Springs
Call for pricing. The number moves with square footage, what's coming out, any asbestos work first, permits, utility work and disposal. Our selective demolition page explains each.
Interior demolition around Colorado Springs
Springs jobs run from our Pueblo West shop, about 40 miles south. For Pueblo addresses, see selective demolition in Pueblo.
Colorado Springs demolition questions
Call and talk it through. Most estimates are done over the phone.
Call 719-299-3887Possibly. PPRBD's wrecking permit is only for removing a whole structure. Interior, non-load-bearing work "may require an interior non load bearing demolition permit," so ask PPRBD about your scope.
A licensed wrecking contractor's ID number, proof of insurance, proof that gas and electric are cut off, and the CDPHE permit for asbestos and debris removal, which comes first.
Its guidance says removals are typically completed in 5 to 10 business days.
Yes, once the job crosses Colorado's asbestos amounts; the material has to be sampled, or handled as asbestos, before the strip-out. Removing a load-bearing part is demolition, which always needs notice to CDPHE.
We hold Colorado's asbestos abatement certification (CDPHE No. 26153), so asbestos found before a Springs strip-out can come out under our crew. Our crews do the demolition too.
Ready for an estimate?
Tell us about the job and we’ll walk you through the next steps.
Call 719-299-3887- Open Monday to Friday, 7 a.m. to 5 p.m.
- Homes and businesses
- Pueblo, Colorado Springs and nearby towns